Heater-A/C Control Replacement

REMOVAL

Center Bezel:

1. Remove instrument panel center bezel. Disconnect the cigar lighter, power window switch and rear window defogger switch (if equipped) wire connectors.

Instrument Panel:

2. Remove knee blocker right and left sides.
3. Remove headlamp switch knob. Using a stiff wire or a small tool, insert it into the hole at the bottom of the knob. Pushing up with the tool and gently pull rearward till the lock tab releases the knob. Remove knob. Use care not to break the locking tab.
4. Remove the steering column shroud and it may require lowering of the steering column for additional clearance.
5. Remove instrument panel bezel. Use care not to break the locking tab.

Heater Control:

6. Remove screws and pull control assembly rearward. Reach behind control and disconnect the wire connectors, vacuum lines and temperature control cable and remove switch.

INSTALLATION
- For installation reverse the above procedures.