Removal and Installation

REMOVAL
1. Remove camshaft sprockets.
2. Remove rocker arm assemblies.
3. Remove upper intake manifold assembly.
4. Remove distributor.
5. Remove exhaust manifolds and cross over.
6. Remove cylinder head bolts and remove cylinder head.

INSTALLATION
1. Clean surfaces of head and block, install head gasket over locating dowels.
2. Install head on locating dowels.
3. Install 10mm allen hex head bolts with washers.
4. Tighten bolts in the order shown. When tightening the cylinder head bolts, tighten gradually, working in two or three steps and finally tighten to specified torque of 108 Nm (80 ft. lbs.).