Horn Chirp Cancellation

HORN CHIRP CANCELLATION


During the programming operation the horn chirp can be disabled using the following procedures:

1. Remove left knee panel.
2. Locate program lead a dark green wire with a molded connector on the end. Located right of steering column near the data link connector.
3. Turn ignition switch ON.
4. Connect the program lead from the remote entry module to ground.
5. Press button on the transmitter to set code. If there is a second transmitter it has to be set at this time. The horn will chirp to confirm programming.
6. Press LOCK then UNLOCK transmitter buttons repeat three times.
7. Remove ground from program lead to restore normal system operation.
8. To reinstate the Horn Chirp feature, refer to Program Remote Entry Receiver.