Rear Door Panel: Service and Repair

Rear Door Trim Panel With Power Windows:

WITH POWER WINDOWS
1. Lower glass to down position.
2. Disconnect battery negative cable.
3. Remove screw holding latch release handle bezel to floor. Slide bezel forward and separate from door trim.
4. Remove ash tray. Remove screw holding trim panel to door from ash tray opening.
5. Pry power window switch from retainer in door trim and disconnect wire connector.
6. Using a suitable trim clip tool, disengage frog leg clips at the ends and bottom of trim panel. After all trim clips ire loose, push inward at the top of the trim panel d lift upward to disengage barb fasteners at top of panel. Separate trim from door.
7. Reverse the preceding operation for installation.

Rear Door Trim Panel With Manual Window:

WITH MANUAL WINDOWS
1. Lower glass to down position.
2. Remove screw holding latch re]ease handle bezel to door. Slide bezel forward and separate from door trim,
3. Remove ash tray. Remove screw holding trim panel to door from ash tray opening.
4. Pry window crank cap from crank. Remove screw holding crane to regulator and separate from door.
5. Using a suitable trim clip tool, disengage frog leg clips at the ends and bottom of trim panel. After all trim clips are loose, push inward at the top of the trim panel and lift upward to disengage barb fasteners at top of panel. Separate trim from door.
6. Reverse the preceding operation for installation.

Rear Door Silencer And Water Shield:

REAR DOOR SILENCER AND WATER SHIELD
1. Remove door trim panel.
2. Remove push-in fasteners holding silencer pad to door inner panel and separate silencer from door.
3. Pull water shield from adhesive around perimeter of door inner panel.
4. Reverse the preceding operation for installation.