Horizontal & Vertical Adjustments

Headlight Aiming: Horizontal Adjusting:

HORIZONTAL ADJUSTING
Insert a screwdriver in the horizontal adjusting hole and turn until the "0" mark and the center line are in alignment.
NOTE:
The beam angle will change about 0°23' with on mark.

Headlight Aiming: Vertical Adjusting:

Headlight Aiming: Vertical Angle Gauge:

VERTICAL ADJUSTING
Adjust the vertical angle with the vertical adjusting gear so that the bubble of the vertical angle gauge is aligned with the "0" mark position.
NOTE:
The beam angle will change about 0°12' with on mark.