NS-10X Injector No. 5 Control Wire

Complete No Start Test 10, Step R before proceeding.

1. With the ignition switch Off, disconnect injector connector 4 from injector.
2. Disconnect injector harness 4-way connector from engine harness, then connect an ohmmeter between the white wire at injector No. 5 connector and the white wire at the injector harness 4-way connector.
3. If ohmmeter shows continuity, replace injector No. 5.
4. If ohmmeter shows no continuity, repair the white wire for an open circuit in the injector harness.