NS-10Q Injector No. 3 Control Wire

Complete No Start Test 10, Step P before proceeding.

1. With the ignition switch Off, disconnect injector connector 3 from injector.
2. Disconnect injector harness 4-way connector from engine harness, then connect an ohmmeter between the tan wire at injector No. 3 connector and the tan wire at the injector harness 4-way connector.
3. if ohmmeter shows continuity, replace injector No. 3.
4. If ohmmeter shows no continuity, repair the tan wire for an open circuit in the injector harness.