NS-10O Injector No. 2 Control Wire

Complete No Start Test 10, Step K before proceeding.

1. With ignition switch Off, disconnect injector connector from No. 3 injector connector then disconnect injector harness 4-way connector from the engine harness connector.
2. Connect an ohmmeter between the tan wire at injector 2 connector and the tan wire at the injector harness 4-way connector.
3. If ohmmeter shows continuity, replace injector No. 2.
4. If ohmmeter shows no continuity, repair the tan wire for an open circuit in the injector harness.