NS-10N Checking 2 & 3 Control Wire For Open to SMEC

Complete No Start Test 10, Step M before proceeding.

1. With ignition Off and 14-way connector disconnected from SMEC, connect an ohmmeter between terminal No. 10 of 14-way connector and tan wire of injector connectors 2, and then 3.
2. If ohmmeter shows continuity, check the terminal in terminal No. 10 of 14-way connector to make sure it is not damaged causing a poor connection. If connector is good, replace the SMEC.
3. If ohmmeter shows no continuity, repair the tan wire of terminal No. 10 of 14-way connector for an open circuit to the injector harness connector.