NS-10I Inj. No. 6 Control Wire For an Open Circuit

Complete No Start Test 10, Step H before proceeding.

1. With ignition switch Off, disconnect injector connector 6 from injector.
2. Disconnect injector harness 4-way connector from the engine harness.
3. Connect an ohmmeter between the yellow/white wire at injector No. 6 connector and the yellow /white wire at the 4-way injector harness connector.
4. If ohmmeter shows continuity, replace injector No. 6.
5. If ohmmeter shows no continuity, repair the yellow/white wire for an open circuit in the injector harness.