NS-10G Inj. No. 1 Control Wire

Complete No Start Test 10, Step C before proceeding.

1. Turn ignition switch Off, then disconnect injector connector No. 6 from injector.
2. Disconnect injector harness 4-way connector from the engine harness connector.
3. Connect an ohmmeter between the yellow/white wire at injector No. 1 connector and the yellow/white wire at the injector harness 4-way connector.
4. If ohmmeter shows continuity, replace injector No. 1.
5. If ohmmeter shows no continuity, repair the yellow/white wire for an open circuit in the injector harness.