Component Tests and General Diagnostics

CLUTCH SWITCH

1. INSPECTION OF CLUTCH SWITCH

(1) Inspection of clutch pedal

A Ensure that the clutch pedal installation height is correct. 02 Ensure that the clutch pedal free travel is correct.

(2) Inspection of clutch start system

A Ensure that the engine will not start when the clutch pedal is released.

B Ensure that the engine can start when the clutch pedal is depressed fully. Adjust or replace the clutch switch, as required.







2. INSPECTION

Refer to CLUTCH section for replacement procedure.

Unit inspection of clutch switch (if necessary)

(1) Disconnect the coupler of the clutch switch. Connect an ohmmeter.

(2) When the clutch switch is pressed (in the ON state), ensure that there is continuity between both poles.

(3) When the clutch switch is released (in the OFF state), ensure that there is no continuity between both poles.

(4) Securely connect the coupler of the clutch switch.