Transaxle Rear Case and C-1 Accumulator Piston

Disassembly Procedure

Notice: Do not spread the seal rings ends more than necessary.





1. Remove the seal rings.





2. Remove the C-1 accumulator cover.





3. Remove the spring and the C-1 accumulator piston.





4. Remove and discard the O-ring from the C-1 accumulator piston.





5. Inspect the spring.
- Using vernier calipers, measure the free length and outer diameter of the spring. If it does not meet specifications, replace it.





Valve Spring Table

Assembly Procedure
1. Clean the components using a clean, high-quality parts cleaning solvent and use compressed air to dry all parts. Inspect all parts for damage or wear.

Notice: Apply TOTAL FLUID HX to the O-ring and the C-1 accumulator piston cavity.





2. Install a new O-ring on the C-1 accumulator piston.





3. Install the C-1 accumulator piston and the spring.





4. Install the C-1 accumulator cover.
- Tighten the bolts to 71 - 106 inch lbs. (8 - 12 Nm).

Notice: Apply TOTAL FLUID HX to the seal rings. Do not spread the seal rings ends more than necessary.





5. Install the seal rings.