Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com
Home >> Daewoo >> 2001 >> Lanos SE Hatchback L4-1.6L DOHC D-TEC MFI >> Repair and Diagnosis >> Steering and Suspension >> Suspension >> Control Arm >> Control Arm Bushing >> Service and Repair >> Front

Front

CONTROL ARM BUSHINGS

- Tools Required
- KM-508-A Remover/Installer
- KM-158 Remover/Installer
- KM-307-B Removal Plate

Disassembly Procedure
1. Remove the control arm.





2. Press off the rear bushing using a press, the remover/installer KM-158, and the removal plate KM-307-B.





3. Press out the front bushing using the remover/installer KM-508-A, and the remover/installer KM-158.

Assembly Procedure
1. Coat the control arm rear shaft with a multipurpose lubricant.





2. Press the rear bushing onto the shaft. The flat of the bushing must be on the top side, the same as the ball joint. Use the remover/installer KM-508-A to support the control arm.
3. Coat the outside of the front bushing and the inside of the lower control arm with a multipurpose lubricant.





4. Press the new bushing into the control arm from the back to the front, using the remover/installer KM-508-A.
5. Center the bushing.
6. Install the control arm.
pro multis · About Operation CHARM