Clutch Switch: Service and Repair

CLUTCH PEDAL POSITION SWITCH
Removal Procedure





1. Remove the clutch pedal position switch by rotating the switch and pulling it from the rear of the clutch pedal bracket.
2. Disconnect the electrical connector.


Installation Procedure





1. Connect the electrical connector.
2. Install the clutch pedal position switch by inserting it from the rear of the clutch pedal bracket and rotating the switch until it locks into position.


Adjustment Procedure





After the clutch pedal position switch is installed, adjust it in the following manner:
1. Confirm that the engine starts when the clutch pedal is fully pressed down.
2. If the engine does not start when the clutch pedal is fully pressed down, turn the clutch pedal position switch adjusting screw until the clutch pedal position switch is engaged so that the engine will start. Do not adjust the screw so far down that it damages the clutch pedal position switch.
3. Confirm that the engine does not start when the clutch pedal is released.
4. If the engine starts when the clutch pedal is released completely, replace the clutch pedal position switch.