Output Shaft Speed (OSS) Sensor

Removal Procedure





1. Disconnect the output shaft speed (OSS) sensor electrical connector.





2. Using the appropriate Torx(R) fastener tool, remove the OSS sensor retaining bolt, then grasp the body of the OSS sensor and remove it from the transaxle.

Installation Procedure





Notice: Lubricate the O-ring with TOTAL FLUID HX.

1. Install a new O-ring on the output shaft speed (OSS) sensor.

2. Install the OSS sensor and retaining bolt into the transaxle case.
Tighten
- Tighten the OSS sensor retaining bolt to 35 - 62 inch lbs. (4 - 7 Nm).





3. Connect the (OSS) sensor electrical connector.