Input Shaft Speed (ISS) Sensor

Removal Procedure





1. Remove the transaxle left bracket.
2. Disconnect the input shaft speed (ISS) sensor electrical connector.





3. Using the appropriate Tory fastener tool, remove the ISS sensor retaining bolt, then grasp the body of the ISS sensor and remove it from the transaxle.

Installation Procedure





Notice: Lubricate the O-ring with TOTAL FLUID HX.

1. Install a new O-ring on the ISS sensor.
2. Install the ISS sensor and retaining bolt into the transaxle case.
- Tighten the ISS sensor retaining bolt to 35 - 62 inch lbs. (4 - 7 Nm).





3. Connect the ISS sensor electrical connector.
4. Install the transaxle left bracket.