Transaxle Rear Case and C-1 Accumulator Piston

Disassembly Procedure





Notice: Do not spread the seal rings ends more than necessary.

1. Remove the seal rings.





2. Remove the C-1 accumulator cover.





3. Remove the spring and the C-1 accumulator piston.





4. Remove and discard the O-ring from the C-1 accumulator piston.





5. Inspect the spring.





- Using vernier calipers, measure the free length and outer diameter of the spring. If it does not meet specifications, replace it.

Assembly Procedure





1. Clean the components using a clean, high-quality parts cleaning solvent and use compressed air to dry all parts. Inspect all parts for damage or wear.

Notice: Apply TOTAL FLUID HX to the O-ring and the C-1 accumulator piston cavity.

2. Install a new O-ring on the C-1 accumulator piston.





3. Install the C-1 accumulator piston and the spring.





4. Install the C-1 accumulator cover.
- Tighten the bolts to 71 - 106 inch lbs. (8 - 12 Nm).





Notice: Apply TOTAL FLUID HX to the seal rings. Do not spread the seal rings ends more than necessary.

5. Install the seal rings.