P0758

Conditions for Setting the DTC
- The Transmission Control Module (TCM) detects an OFF signal from the Shift Solenoid 2 (SS2) monitor for 300 milliseconds when the SS2 driver outputs the ON signal. (The SS2 circuit is shorted to ground.)
- The TCM detects an ON signal from the SS2 monitor for 500 milliseconds when the SS2 driver outputs the OFF signal. (The SS2 circuit is open.)

Action Taken When the DTC Sets
- TCM will request the illumination of MIL and store DTC when TCM detects a failure on the first ignition cycle.
- 4th gear is held in "D" range.
- 4th gear is held in "2" range.
- 1st gear is held in "L" range.
- No TCC lockup control.
- Full line pressure.

Conditions for Clearing the MIL/Power Lamp/DTC
- The TCM turns off the MIL when no further failures detected for three consecutive ignition cycles.
- The Scan-100 scan tool can clear the DTC from the TCM history.
- The TCM clears the DTC from the TCM history memory after forty consecutive ignition cycles without fault while it does not detect a failure for 1 second.