P0742

Conditions for Setting the DTC
- The transaxle is in 2nd or 3rd gear and the Transmission Control Module (TCM) is not commanding the Torque Converter Clutch (TCC) solenoid ON.
- The throttle opening is between 20 and 100%.
- The vehicle speed is between 2 mph (5 km/h) and 43 mph (70 km/h).
- 20 seconds have passed since transaxle was placed in D.
- The brake switch is OFF.
- Engine Coolant Temperature (ECT) is normal.
- Transmission Fluid Temperature (TFT) is greater than 20°C.
- Engine rpm is greater than 400.
- DTC(s) P0705, P0712, P0713, P0717, P0722, P0727, P0743, P0753, P0758 and P1701 not set.

Action Taken When the DTC Sets
- TCM will request the illumination of MIL and store DTC when TCM detects failures on two consecutive ignition cycle.

Conditions for Clearing the MIL/Power Lamp/DTC
- The TCM turns off the MIL when no further failures detected for three consecutive ignition cycles.
- The Scan-100 scan tool can clear the DTC from the TCM history.
- The TCM clears the DTC from the TCM history memory after forty consecutive ignition cycles without fault.