P0722

Conditions for Setting the DTC
- The Transmission Control Module (TCM) cannot detect a pulse from the Output Shaft Speed (OSS) sensor while it detects 10 pulses of the Input Shaft Speed (ISS) sensor signal 500 times continuously.
- ISS sensor signal is greater than 2 mph (4 km/h).
- 10 seconds after Neutral to Drive shift.
- 2.5 seconds after Neutral to Drive shift and Transmission Fluid Temperature (TFT) is greater than 0°C.
- ISS sensor signal is greater than 41 mph (66 km/h) for 2.5 seconds after Neutral to Drive shift.
- DTC P0705, P0712 and P0713 not set.

Action Taken When the DTC Sets
- TCM will request the illumination of MIL and store DTC when TCM detects failures on two consecutive ignition nunlr3
- The TCM selects ISS signal for vehicle speed.
- No TCC lockup control.
- No torque converter reduction control.
- No line pressure reduction control.

Conditions for Clearing the MIL/Power Lamp/DTC
- The TCM turns off the MIL when no further failures detected for three consecutive ignition cycles.
- The Scan-100 scan tool can clear the DTC from the TCM history.
- The TCM clears the DTC from the TCM history memory after forty consecutive ignition cycles without fault while it detects that the OSS signal is greater than 6 mph (10 km/h) for 30 seconds continuously.