P0717

Conditions for Setting the DTC
- The Transmission Control Module (TCM) cannot detect a pulse from the Input Shaft Speed (ISS) sensor while it detects 6 pulses of the Output Shaft Speed (OSS) sensor signal 500 times continuously.
- OSS sensor signal is greater than 4 mph (7 km/h) in 1st gear, 8 mph (13 km/h) in 2nd gear, 11 mph (18 km/h) in 3rd gear or 16 mph (12 km/h) in 4th gear.
- 10 seconds after Neutral to Drive shift.
- 2.5 seconds after Neutral to Drive shift and Transmission Fluid Temperature (TFT) is greater than 0°C.
- ISS sensor signal is greater than 41 mph (66 km/h) for 2.5 seconds after Neutral to Drive shift.
- Engine rpm is 400 or greater.
- DTC(s) P0705,P0712,P0713 and P0727 not set.

Action Taken When the DTC Sets
- TCM will request the illumination of MIL and store DTC when TCM detects failures on two consecutive ignition cycle.
- No TCC lockup control.
- No torque converter reduction control.
- No line pressure reduction control.

Conditions for Clearing the MIL/Power Lamp/DTC
- The TCM turns off the MIL when no further failures detected for three consecutive ignition cycles.
- The Scan-100 scan tool can clear the DTC from the TCM history.
- The TCM clears the DTC from the TCM history memory after forty consecutive ignition cycles without fault while it detects that the ISS signal is greater than 6 mph (10 km/h) for 30 seconds continuously.