P0705

Conditions for Setting the DTC
- The Transmission Control Module (TCM) cannot detect a signal from the Transmission Range (TR) sensor circuit for 50 seconds continuously.
- Vehicle speed is greater than 18.6 mph (30 Km/h).
- Engine rpm is greater than 1500.
- DTC P0722 and P0727 not set.
- The TCM detects more than two equal signals from the TR sensor circuit for 30 seconds continuously.

Action Taken When the DTC Sets
- TCM will request the illumination of MIL and store DTC when TCM detects failures on two consecutive ignition cycle.
- No TCC lockup control.

Conditions for Clearing the MIL/Power Lamp/DTC
- The TCM turns off the MIL when no further failures detected for three consecutive ignition cycles.
- The Scan-100 scan tool can clear the DTC from the TCM history.
- The TCM clears the DTC from the TCM history memory after forty consecutive ignition cycles without fault.