Output Shaft Speed (OSS) Sensor

OUTPUT SHAFT SPEED (OSS) SENSOR

Removal Procedure





1. Disconnect the Output Shaft Speed (OSS) sensor electrical connector.





2. Using the appropriate Torx(R) fastener tool, remove the OSS sensor retaining bolt, then grasp the body of the OSS sensor and remove it from the transaxle.

Installation Procedure

Notice: Lubricate the O-ring with Texaco 1854 automatic transmission fluid.





1. Install a new O-ring on the Output Shaft Speed (OSS) sensor.
2. Install the OSS sensor and retaining bolt into the transaxle case.
Tighten
Tighten the OSS sensor retaining bolt to 4 - 7 Nm (35 - 62 inch lbs.).





3. Connect the OSS sensor electrical connector.