Input Speed Sensor

INPUT SHAFT SPEED (ISS) SENSOR

Removal Procedure
1. Remove the transaxle left bracket.





2. Disconnect the Input Shaft Speed (ISS) sensor electrical connector.





3. Using the appropriate Torx(R) fastener tool, remove the ISS sensor retaining bolt, then grasp the body of the ISS sensor and remove it from the transaxle.

Installation Procedure

Notice: Lubricate the O-ring with Texaco 1854 automatic transmission fluid.

1. Install a new O-ring on the Input Shaft Speed (ISS) sensor.





2. Install the ISS sensor and retaining bolt into the transaxle case.
Tighten
Tighten the ISS sensor retaining bolt to 4 - 7 Nm (35 - 62 inch lbs.).





3. Connect the ISS sensor electrical connector.
4. Install the transaxle left bracket.