Removal and Installation

Removal Procedure




1. Remove the engine intake manifold-to-engine block strap bracket over the starter.
2. Remove the starter-to-transmission mounting bolt.
3. Remove the starter-to-engine block mounting bolt.




4. Remove the starter solenoid nuts to disconnect the electrical cable.
5. Remove the starter assembly.

Installation Procedure




1. Place the starter assembly in position.
2. Install the upper and the lower starter mounting bolts.

Tighten
Tighten the starter4o-engine block mounting bolt to 45 Nm. (33 lb.ft).

Tighten
Tighten the starter-to-transmission mounting bolt to 50 Nm. (37 lb.ft).

3. Install the engine intake manifold-to-engine block strap bracket over the starter.

Tighten
Tighten the intake manifold-to-engine block bracket bolts (over starter) to 20 Nm. (15 lb.ft).




4. Position the starter electrical wire on the solenoid terminal.
5. Install the starter solenoid terminal-to-ignition solenoid terminal nut.

Tighten
Tighten the starter solenoid terminal-to-ignition solenoid terminal nut to 6 Nm. (53 lb.in).

6. Install the starter solenoid terminal-to-battery cable terminal nut.

Tighten
Tighten the starter solenoid terminal-to-battery cable terminal nut to 7 Nm. (62 lb.in).