Speed Sensor

Removal Procedure
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle.





3. Remove the bolt and the rear wheel speed sensor from the rear knuckle.





4. Remove the speed sensor cable grommets from their clamps.
5. Remove the speed sensor cable from the clamps securing it to the hydraulic pipe.
6. Remove the speed sensor cable connector from its clamps and disconnect the speed sensor cable from the harness.

Installation Procedure





1. Install the rear wheel speed sensor to the rear knuckle. Secure it with the bolt.
Tighten
Tighten the rear wheel speed sensor bolt to 8 Nm (71 inch lbs.).
2. Connect the rear wheel speed sensor electrical connector.
3. Secure the speed sensor cable into its clamps on the hydraulic pipe.





4. Secure the speed sensor cable grommets into their clamps inside the fender well.
5. Lower the vehicle.
6. Connect the negative battery cable.