Jumper Harness

Removal Procedure
1. Remove the negative battery cable.
2. Raise and suitably support the vehicle.
3. Remove the left front wheel.
4. Remove the wheel well splash shield inside the left front wheel arch to expose the body wiring harness where it enters the engine compartment.





5. Disconnect the body harness from the ABS harness at connector C107. This is forward of the left front wheel arch, between the engine fuse block and the wheel arch.
6. Pull the body harness end of C107 into the wheel arch area and remove the DK BLU-BRN pair of speed sensor wires appropriate for the harness being replaced.





7. Open the body harness cover enough to free the speed sensor harness being replaced.
8. Lower the vehicle.
9. Expose the body harness inside the vehicle body and free the speed sensor harness being replaced.
10. Open the trunk, uncover the spare tire compartment, remove the tape from the feed through grommet, and free the speed sensor harness from the body harness.
11. Raise and suitably support the vehicle.
12. Disconnect the speed sensor cable from the sensor harness cable being replaced.
13. Remove the tape sealing the wiring harness and the rear speed sensor harnesses to the grommet passing them through the floor of the vehicle.
14. Pull the harness being replaced through the grommet.

Installation Procedure
1. Pass the harness through the grommet in the floor.
2. Connect the new wheel speed sensor harness to the wheel speed sensor.
3. Secure the connector in its clamp.
4. Adjust the cable length and tape the grommet opening under the vehicle.
5. Lower the vehicle.
6. Tape the grommet opening inside the vehicle.





7. Pass the harness through the grommet and on into the engine compartment.
8. Install terminals onto the harness wires and insert the new terminals into the appropriate cavities of connector C107.
9. Reconnect connector C107 to the ABS harness.
10. Secure the new speed sensor harness into the body wiring harness.
11. Replace the wheel well splash shield.
12. Replace the left front wheel.
13. Lower the vehicle.
14. Connect the negative battery cable.