Ignition Coil: Service and Repair

ELECTRONIC IGNITION SYSTEM IGNITION COIL

Removal Procedure




1. Disconnect the negative battery cable.
2. Disconnect the electronic ignition (EI) system ignition coil connector.
3. Note the ignition wire location and remove the ignition wires.
4. Remove the EI system ignition coil retaining bolts.
5. Remove the EI system ignition coil.

Installation Procedure




1. Install the EI system ignition coil into the mounting location and install the retaining bolts.

Tighten: Tighten the electronic ignition system ignition coil re taming bolts to 10 Nm (89 lb-in).

2. Connect the EI system ignition coil connector.
3. Install the ignition wires.
4. Connect the negative battery cable.