Campaign - Post Heated O2 Sensor Wiring Inspection
Product Update InspectionSubject:
Leganza Post Heated Oxygen Sensor Wiring
Date: March 16,1999
Number: PU-004-99
A possibility exists that the Post (rear) Heated 02 Sensor wiring for some Leganza models may become damaged through contact with the front engine mount bracket.
To prevent this condition from occurring, the following conduit installation procedure has been developed to provide additional protection for the Post H02 Sensor wire harness.
This procedure should be performed on all vehicles currently in inventory before they are delivered to a customer. Customer vehicles should be updated during their next service visit.
Update Procedure:
1. From the engine compartment, disconnect the Post H02 Sensor Wire Harness Connector.
2. Using needle-nose pliers, release the retaining clip and remove the Post H02 Sensor Connector from its mounting bracket.
3. Inspect the wiring harness for damage and repair or replace as necessary.
4. Starting just behind the connector, install the plastic conduit over the Post H02 Sensor Wiring.
5. Continue installing the conduit until the end of the conduit is fully installed over the sensor wire harness.
6. Re-attach the Post H02 Sensor Connector to the mounting bracket.
7. Re-connect the Post H02 Sensor Wire Harness Connector.
PARTS INFORMATION
WARRANTY CLAIM INFORMATION