Compressor Control Valve Assembly: Service and Repair
Tools RequiredJ-5403 Snap Ring Pliers
Removal Procedure
1. Recover the refrigerant.
2. Remove the control valve retaining ring using the snap ring pliers J-5403.
3. Remove the control valve assembly.
Installation Procedure
1. Coat all the O-rings with clean polyalkaline glycol (PAG) oil.
2. Push the control valve in place using thumb pressure.
3. Use the snap ring pliers J-5403 to install the valve retaining ring. The high point of the curved sides must be against the valve housing. Be sure the retaining ring is properly seated in the ring groove.
4. Evacuate and recharge the A/C system.