P0753
DTC P0753 - SHIFT SOLENOID 1 (SS1) ELECTRICALConditions for Setting the DTC
- The Transmission Control Module (TCM) detects an OFF signal from the Shift Solenoid 1 (SS1) monitor for 300 milliseconds when the SS1 driver outputs the ON signal.
- The TCM detects an ON signal from the SS1 monitor for 500 milliseconds when the SS1 driver outputs the OFF signal.
Action Taken When the DTC Sets
- The TCM illuminates the Malfunction Indicator Lamp (MIL) after two consecutive trips with a failure reported.
- 4th gear is held in "D" range.
- 4th gear is held in "3" range.
- 1st gear is held in "L" range.
- No Torque Converter Clutch (TCC) lockup control.
- Full line pressure.
Conditions for Clearing the MIL/DTC
- The TCM turns off the MIL after three consecutive trips without a failure reported.
- The Scan-100 scan tool can clear the Diagnostic Trouble Code (DTC) from the TCM history.
- The TCM clears the DTC from the TCM history if it does not detect a failure for 1 second.
DTC P0753 - Shift Solenoid 1 (SS1) Electrical