P0712

DTC P0712 - TRANSMISSION FLUID TEMPERATURE (TFT) SENSOR CIRCUIT LOW INPUT
Conditions for Setting the DTC
- The Transmission Control Module (TCM) detects that the voltage of the Transmission Fluid Temperature (TFT) sensor signal is less than 50 mV for 5 minutes continuously.

Action Taken When the DTC Sets
- The TCM illuminates the power lamp after two consecutive trips with a failure reported.
- No increase in line pressure at low temperature.
- No auto mode change at high temperature.

Conditions for Clearing the MIL/DTC
- The TCM turns off the power lamp after three consecutive trips without a failure reported.
- The Scan-100 scan tool can clear the Diagnostic Trouble Code (DTC) from the TCM history.
- The TCM clears the DTC from the TCM history if it detects that the ATF temperature is between 0°C and 150°C for 15 minutes continuously.








DTC P0712 - Transmission Fluid Temperature (TFT) Sensor Circuit Low Input