Speed Sensor Jumper Harness

Removal Procedure
1. Remove the negative battery cable.
2. Raise and suitably support the vehicle.





3. Disconnect the rear wheel speed sensor electrical connectors at both wheels.
4. Remove connector C902 from its mounting by pinching the retainer clips and pushing the retainer up and out of its mounting hole in the axle.





5. Unplug the rear jumper harness from connector C902.





6. Release both branches of the harness from the retainers and remove it from the vehicle.

Installation Procedure
1. Connect the new wheel speed sensor harness to both wheel speed sensors.





2. Plug the harness connector into C902.
3. Secure the harness into its retainers.





4. Push the retainer clamp of C902 into its mounting hole.
5. Lower the vehicle.
6. Connect the negative battery cable.