Oil Pressure Inspection

ENGINE OIL PRESSURE INSPECTION
PROCEDURE

- Tools Required
- KM-498-B Pressure Gauge
- KM-135 Adapter
1. Remove the front, right-hand wheel well splash shield.





2. Disconnect the oil pressure switch connector.





3. Install the adapter KM-135 in place of the oil pressure switch.
4. Connect the pressure gauge KM-498-B to the adapter.
5. Start the engine and check the oil pressure at idle speed and engine temperature of 80°C (176°F). The minimum oil pressure should be 30 kPa (8.88 psi).
6. Turn the engine OFF and remove the oil pressure gauge and adapter.
7. Install the oil pressure switch.
Tighten the oil pressure switch to 40 Nm (30 ft. lbs.).





8. Connect the oil pressure switch connector.
9. Install the lower front, right-hand wheel well splash shield.
10. Check the oil level and fill to the full mark.