Exhaust Muffler Replacement (1500 Series and 6.2L)

Exhaust Muffler Replacement (1500 Series and 6.2L)

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the spare tire, if necessary.
3. Install adjustable jack stands under the rear axle, if necessary.
4. If equipped with a 8.6 or a 9.5 inch ring gear, remove the rear axle vent hose from the rear axle, if necessary.
5. Remove the vent hose swivel clip from the rear brake crossover pipe, if necessary.




6. If equipped with a 10.5 inch ring gear, remove the rear axle vent hose from the rear axle, if necessary.
7. Remove the vent hose swivel clip from the rear brake crossover pipe, if necessary.




8. Remove the rear shock absorber lower bolts and nuts, if necessary.
9. Lower the rear axle using the adjustable jack stands, if necessary.




10. Remove the catalytic converter to muffler nuts.




11. If equipped with a exhaust muffler clamp (Norma), loosen the catalytic to exhaust muffler clamp nut (1).




12. Lubricate the 5 insulators where the muffler assembly hangers are inserted in order to ease removal.
13. With the aid of an assistant, remove the insulators (1-3) from the front, intermediate and rear muffler assembly hangers.




14. Remove the insulator (1) from the tail pipe hanger and remove the muffler assembly.

Installation Procedure




1. Lubricate the 5 insulators where the muffler assembly hangers are inserted in order to ease installation.
2. With the aid of an assistant, position and install the muffler assembly.
3. Install the insulator (1) to the rear tail pipe hanger.




4. Install the insulators (1-3) to the front, intermediate, and rear muffler assembly hangers.





Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the catalytic converter to muffler nuts and tighten to 45 Nm (33 lb ft).




6. For mufflers using a exhaust muffler clamp (Norma), install the catalytic converter to the exhaust muffler nut (1) and tighten the clamp to 28 Nm (21 lb ft)




7. Raise the rear axle using the adjustable jack stands, if necessary.
8. Install the rear shock absorber lower bolts and nuts, if necessary and tighten to 95 Nm (70 lb ft).




9. If equipped with a 10.5 inch ring gear, install the rear axle vent hose to the rear axle, if necessary.
10. Connect the vent hose swivel clip to the rear brake crossover pipe, if necessary.




11. If equipped with a 8.6 or a 9.5 inch ring gear, install the rear axle vent hose to the rear axle, if necessary.
12. Install the vent hose swivel clip to the rear brake crossover pipe, if necessary.
13. Remove the adjustable jack stands from under the rear axle, if necessary.
14. Install the spare tire, if necessary.
15. Lower the vehicle.