Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side

Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side

Removal Procedure

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




2. Disconnect the transfer case right rear speed sensor electrical connector.
3. Remove the transfer case speed sensor.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the transfer case right rear speed sensor.

Tighten the speed sensor to 17 Nm (13 lb ft).

2. Connect the transfer case right rear speed sensor electrical connector.
3. Lower the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).