2. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Special Tools
* EN 46359 - Puller End Protector
* EN-49010 - Flywheel Holding Tool
* J 41816-A - Crankshaft Balancer Remover

For equivalent regional tools, refer to Special Tools (Special Tools).




1. Install the EN-49010 - tool to the starter mounting holes.




2. Remove the crankshaft balancer bolt and washer.





Caution: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.

3. Remove the crankshaft balancer using the J 41816-A - remover along with EN 46359 - protector or equivalent.
4. Remove the EN-49010 - tool.