Upper Rear Trim Finish Panel Replacement

Upper Rear Trim Finish Panel Replacement

Tools Required

J 38778 Door Trim Pad Clip Remover

Removal Procedure




1. Remove the upper seat belt anchor bolt from the belt guide loop.

Important: Use care to not break the locating tabs on the quarter trim when removing the back body pillar trim.


2. UsingJ 38778 remove the back body pillar trim from the vehicle.

Installation Procedure




1. Install the back body pillar trim by aligning the trim with the locating tabs on the quarter trim.
2. Align the retainers in the holes and push to secure the retainers.

Notice: Refer to Fastener Notice (Fastener Notice).

3. Install the upper seat belt anchor bolt to the belt guide loop.

Tighten the bolt to 43 N.m (32 lb ft).