Upper Sliding Door Roller: Service and Repair

Rear Side Door Upper Roller Bracket Replacement

Removal Procedure

1. Remove the sliding door garnish molding. Refer to Rear Side Door Garnish Molding Replacement ().
2. Remove the headliner trim finish molding. Refer to Headlining Trim Panel Molding Replacement (Service and Repair).
3. Support the sliding door.




4. Mark the location of the sliding door upper roller bracket (1) to the door (2) with a grease pencil.
5. Remove the sliding door upper roller bracket bolts.




6. Remove the sliding door upper roller bracket from the front edge of the upper track.

Installation Procedure




1. Install the sliding door upper roller bracket to the front edge of the upper track.




2. Align the sliding door upper roller bracket (1) to the grease pencil marks.

Notice: Refer to Fastener Notice (Fastener Notice).

3. Install the sliding door upper roller bracket bolts.

Tighten the sliding door upper roller bracket bolts, in sequence as shown, to 10 N.m (89 lb in).

4. Remove the support from the sliding door.
5. Adjust the sliding door, if needed. Refer to Sliding Rear Side Door Adjustment (Adjustments).
6. Install the headliner trim finish molding. Refer to Headlining Trim Panel Molding Replacement (Service and Repair).
7. Install the sliding door garnish molding. Refer to Rear Side Door Garnish Molding Replacement ().