Headlining Trim Panel Replacement (SWB w/CF5 and U42)
Headlining Trim Panel Replacement (SWB w/CF5 and U42)
Caution: Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material is damaged, replace the headliner and/or the garnish trim. Failure to do so could result in personal injury.
Notice: Use care when working around the head curtain inflator module. Sharp tools may puncture the curtain airbag. If the head curtain inflator module is damaged in any way, it must be replaced.
Notice: If a vehicle is equipped with a head curtain inflator module ensure that the inflator module and tether are undamaged. If tether or curtain airbag are damaged in any way, they must be replaced.
Removal Procedure
1. Disable the roof rail SIR system. Refer to SIR Disabling and Enabling.
2. Remove the front assist handle.
3. Remove the windshield garnish molding.
4. Remove the sunshade assembly and the sunshade retainers.
5. Remove the roof console assembly.
6. Remove the front door sill plate.
7. Remove the rear door sill plate.
8. Remove the center pillar lower molding.
9. Remove the center pillar upper molding.
10. Remove the lock pillar molding.
11. Remove the back body opening molding
12. Remove the body rear corner upper molding.
13. Remove the coat hooks.
14. Remove the sunroof panel window molding.
15. Remove the rear overhead console.
16. Place the rear seats in the stowed position.
17. Remove the front seat headrest.
18. Remove the instrument panel (I/P) upper trim pad.
19. Remove the roof assist handles.
20. Remove the front seat.
21. Remove the second row right seat.
22. Remove the third row right seat
23. Disconnect the electrical harness retainers from the windshield pillars.
24. Disconnect the electrical harness from the BEC under the steering column. Route the wires out.
25. Remove the right side rear quarter trim.
26. Remove the rearview mirror trim and disconnect the electrical connectors.
27. Remove the sunshade anchor.
28. Note routing of the wire harness and remove the headliner trim panel assembly (3).
Installation Procedure
1. Install the headliner trim panel assembly (3).
2. Install the sunshade anchor.
3. Install the rearview mirror trim and connect the electrical connectors.
4. Install the right side rear quarter trim.
5. Connect the electrical harness to the BEC under the steering column.
6. Connect the electrical harness retainers to the windshield pillars.
7. Install the third row right seat.
8. Install the second row right seat.
9. Install the front seat.
10. Install the roof assist handles.
11. Install the I/P upper trim pad.
12. Install the front seat headrest.
13. Install the rear overhead console.
14. Install the sunroof panel window molding.
15. Install the coat hooks.
16. Install the body rear corner upper molding.
17. Install the back body opening molding.
18. Install the lock pillar molding.
19. Install the center pillar upper molding.
20. Install the center pillar lower molding.
21. Install the rear door sill plate.
22. Install the front door sill plate.
23. Install the roof console assembly.
24. Install the sunshade assembly and the sunshade retainers.
25. Install the windshield garnish molding.
26. Install the front assist handle.
27. Enable the roof rail SIR system. Refer to SIR Disabling and Enabling.