Generator Replacement (4.3L)

Generator Replacement (4.3L)

Removal Procedure




1. Disconnect the negative battery cable.
2. Remove the drive belt.
3. Unbolt and reposition the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement.
4. Unbolt and reposition the oil fill tube. Refer to Oil Filler Tube Replacement.
5. Disconnect the engine wiring harness electrical connector (1) from the generator.
6. Remove the oil fill tube bracket stud (2).
7. Reposition the engine wiring harness clip.




8. Reposition the positive battery cable boot (2) at the generator.
9. Remove the generator nut (3).
10. Remove the positive battery cable (1) from the generator.




11. Remove the oil fill tube bracket bolt (2) and bracket (1).




12. Remove the generator bolts (2) and generator (1).

Installation Procedure






Notice: Refer to Fastener Notice.

1. Install the generator (1) and bolts (2).

Tighten the bolts to 50 N.m (37 lb ft).




2. Install the oil fill tube bracket (1) and bolt (2).

Tighten the bolt to 25 N.m (18 lb ft).




3. Install the positive battery cable (1) to the generator.
4. Install the generator nut (3).

Tighten the nut to 12 N.m (106 lb in).

5. Position the positive battery cable boot (2) at the generator.




6. Position the engine wiring harness clip to the generator bracket.
7. Install the oil fill tube bracket stud (2).

Tighten the stud to 25 N.m (18 lb ft).

8. Connect the engine wiring harness electrical connector (1) to the generator.
9. Position and install the oil fill tube. Refer to Oil Filler Tube Replacement.
10. Position and install the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement.
11. Install the drive belt.
12. Connect the negative battery cable.