Cylinder Head Replacement - Left

Cylinder Head Replacement - Left Side

Tools Required

J 45059 Angle Meter

Removal Procedure




1. Drain the engine oil.
2. Drain the cooling system.
3. Lower the vehicle.
4. Remove the lower intake manifold.
5. Remove the exhaust crossover pipe.
6. Remove the oil level indicator tube.




7. Remove the left spark plugs.
8. Remove and discard the cylinder head bolts.
9. Remove the cylinder head.




10. Remove and discard the cylinder head gasket.
11. Remove the cylinder head dowel pins, if necessary.

Installation Procedure





Notice: Head gaskets are specific for right hand and left hand applications, and also must be installed with the correct side facing up. Note the markings (1) on the head gaskets for proper installation. Failure to do so may lead to engine damage.

1. Clean the gasket mating surfaces.
2. Install the spark plugs to the cylinder head.
3. Install the cylinder head locator dowel pins, if necessary.
4. Inspect the cylinder head locator dowel pins for proper installation.




5. Install a NEW cylinder head gasket.




6. Install the cylinder head onto the locator pins and the engine.

Notice:This component uses torque-to-yield bolts. When servicing this component do not reuse the bolts, New torque-to-yield bolts must be installed. Reusing used torque-to-yield bolts will not provide proper bolt torque and clamp load. Failure to install NEW torque-to-yield bolts may lead to engine damage.

7. Install the NEW cylinder head bolts finger tight.





Notice: Refer to Fastener Notice.

8. Tighten the cylinder head bolts.

Tighten the bolts in sequence to 60 N.m (44 lb ft) plus an additional 140 degrees using the J 45059.




9. Install the oil level indicator tube.
10. Install the exhaust manifold.
11. Install the lower intake manifold.
12. Fill the engine with oil.
13. Fill the cooling system.
14. Inspect for leaks.