Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Balancer Replacement

Tools Required

* J 29113 Balancer and Crank Sprocket Installer
* J 37096 Flywheel Holder
* J 41816 Crankshaft Balancer Remover
* J 45059 Angle Meter

Removal Procedure

Notice: The inertial weight section of the crankshaft balancer is assembled to the hub with a rubber type material. The correct installation procedures (with the proper tool) must be followed or movement of the inertial weight section of the hub will destroy the tuning of the crankshaft balancer.




1. Remove the drive belt.
2. Remove the right front tire and wheel.
3. Remove the right engine splash shield.
4. Place adjustable jack stands under the frame.
5. Loosen the left side frame bolts (2) and remove the right side frame bolts (1).
6. Using the jack stands, lower the right side of the frame enough to access the crankshaft balancer.
7. Remove the engine to transmission bracket bolts at the rear lower left side of the engine and transaxle assembly.
8. Remove the engine to transmission bracket from the rear lower left side of the engine and transaxle assembly.




9. Remove the torque converter cover.
10. Install the J 37096 to the flywheel in order to prevent flywheel rotation.
11. Remove the crankshaft balancer bolt and the washer.




12. Remove the crankshaft balancer using the J 41816.

Installation Procedure




1. Apply sealer to the keyway of the crankshaft balancer.
2. Place the crankshaft balancer into position over the key in the crankshaft.
3. Install the J 29113 onto the crankshaft.
4. Rotate the hex nut on the J 29113 in order to install the crankshaft balancer onto the crankshaft.
5. Remove the J 29113 from the crankshaft.





Notice: Refer to Fastener Notice.

6. Install the crankshaft balancer washer and bolt.
^ Tighten the bolt a first pass to 70 N.m (52 lb ft).
^ Tighten the bolt a final pass to 70 degrees using the J 45059.
7. Remove the J 37096 from the flywheel.
8. Install the torque converter cover.
9. Install the engine to transaxle bracket at the rear lower left side of the engine.
10. Install the engine to transaxle bracket bolts at the rear lower left side of the engine.




11. Raise the frame to the original position using the adjustable jacks.
12. Install and tighten the right side frame bolts and tighten the left side frame bolts.
^ Tighten the front frame bolts to 130 N.m (96 lb ft).
^ Tighten the rear frame bolts to 240 N.m (177 lb ft).
13. Remove the jack stands supporting the frame.
14. Install the right engine splash shield.
15. Install the right front tire and wheel.
16. Install the drive belt.