Fastener Tightening Specifications

Connecting Rod Bolts
First Pass 20 N.m (15 lb ft)
Final Pass 75 degrees
Crankshaft Oil Deflector Nuts 25 N.m (18 lb ft)
Crankshaft Position (CKP) Sensor Bolt 25 N.m (18 lb ft)
Crankshaft Rear Oil Seal Housing Bolts 30 N.m (22 lb ft)





Crankshaft Bearing Cap M10 Bolts
First Pass in Sequence 20 N.m (15 lb ft)
Final Pass in Sequence 80 degrees
Crankshaft Bearing Cap M10 Studs
First Pass in Sequence 20 N.m (15 lb ft)
Final Pass in Sequence 51 degrees
Crankshaft Bearing Cap M8 Bolts 25 N.m (18 lb ft)





Crankshaft Balancer Bolt
Installation Pass to Ensure the Balancer is Completely Installed 330 N.m (240 lb ft)
First Pass
Install a NEW Bolt After the Installation Pass and Tighten as Described in the First and Final Passes 50 N.m (37 lb ft)
Final Pass 140 degrees