Transfer Case Output Shaft Seal Replacement - Front

Transfer Case Output Shaft Seal Replacement - Front

Tools Required
^ J 8092 Driver Handle
^ J 43484 Output Shaft Seal Installer

Removal Procedure




1. Remove the transfer case shield, if equipped.
2. Remove the front propeller shaft.
3. Insert a flat-tipped screwdriver into the inner race.
4. Pry the inner race back.




5. Insert a small pry bar into the inner race.




6. Remove the inner race from the seal.




7. Insert a flat-tipped screwdriver or a small pry bar in the space between the outer race of the seal and transfer case.




8. Remove the outer part of the seal.

Installation Procedure




1. Install the J 43484 (2) to the J 8092 (1).
2. Install the seal onto the J 43484.
3. Using the J 43484 (2) and the J 8092 (1), install the seal.
4. Install the front propeller shaft.
5. Check the fluid level. Add fluid if necessary.
6. Install the transfer case shield, if equipped.