Rear Fender Replacement (Standard)

Rear Fender Replacement (Standard)

Removal Procedure





1. Remove the bolts from the front of the fender.
2. Remove the screws in the wheel house attaching the fender to the box.
3. Remove the tail lamp assembly. Refer to Tail/Turn Signal Lamp Replacement (Except Stepside) .
4. Remove the fender to rear pillar retaining bolts through the tail lamp opening.




5. Remove the rear bolts.
6. Use the following procedure in order to remove the fender from the vehicle:

1. Lift the fender at the bottom up 45 degrees.
2. Slide the fender upward to remove.




Installation Procedure

1. Use the following procedure in order to install the fender to the vehicle:

1. Rotate the fender up 45 degrees.
2. Rotate the fender down into the body position.





2. Install the fender to rear pillar retaining bolts through the tail lamp opening.

Notice: Refer to Fastener Notice .

3. Install the rear retaining bolts.

Tighten the bolts to 17 N.m (12 lb ft).

4. Install the tail lamp assembly. Refer to Tail/Turn Signal Lamp Replacement (Except Stepside) .
5. Install the screws in the wheelhouse attaching the fender to the box.

Tighten the screws to 2 N.m (18 lb in).





6. Install the bolts to the front of the fender.

Tighten the bolts to 17 N.m (12 lb ft).