Removal and Replacement

THROTTLE BODY ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE

NOTE: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.

IMPORTANT: An 8-digit part identification number is stamped on the throttle body casting. Refer to this number if servicing, or part replacement is required.




1. Remove the intake air resonator.
2. Disconnect the throttle actuator motor electrical connector (5).

IMPORTANT: Cover or plug any openings when servicing the throttle body in order to prevent possible contamination.




3. Remove the throttle body nuts.

4. Remove the throttle body.
5. Remove and discard the throttle body gasket.

INSTALLATION PROCEDURE




1. Install a NEW throttle body gasket.
2. Install the throttle body.

NOTE: Refer to Fastener Notice.

3. Install the throttle body nuts.

Tighten the nuts to 10 N.m (89 lb in).




4. Connect the throttle actuator motor electrical connector (5).
5. Install the intake air resonator.
6. Connect a scan tool in order to test for proper throttle-opening and throttle-closing range.
7. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
8. Verify that the vehicle meets the following conditions:
- The vehicle is not in a reduced engine power mode.
- The ignition is ON.
- The ignition is OFF.