Fuel Injection Fuel Return Pipe Replacement - Right Side

FUEL INJECTION FUEL RETURN PIPE REPLACEMENT - RIGHT SIDE

REMOVAL PROCEDURE




1. Remove the wiring harness retainer from the bracket.
2. Remove the oil level indicator tube bolt.
3. Remove the oil level indicator tube bracket bolts.
4. Remove the bracket.




5. Remove the fuel filter and bracket.
6. Disconnect the return line from the return/junction block line.
7. Remove the fuel return line clips.
8. Remove the fuel injector return line from the injectors.

INSTALLATION PROCEDURE




1. Install the fuel injector return line to the injectors.
2. Install the fuel return line clips.
3. Connect the return line to the return/junction block line.
4. Install the fuel filter and bracket.




5. Install the bracket.

NOTE: Refer to Fastener Notice.

6. Install the oil level indicator tube bracket bolts.

Tighten the bolts to 21 N.m (15 lb ft).

7. Install the oil level indicator tube bolt.

Tighten the bolt to 21 N.m (15 lb ft).

8. Install the wiring harness retainer to the bracket.
9. Prime the fuel system. Refer to Fuel System Priming.
10. Start the engine. If the engine stalls, repeat the above step.
11. Once the engine starts, inspect for fuel leaks.