Removal and Replacement

THROTTLE BODY ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE




1. Remove the air cleaner outlet resonator.
2. Remove the air cleaner outlet resonator stud.




3. Remove the cruise control cable from the throttle pulley.
4. Remove the cruise control cable from the engine bracket.




5. Remove the accelerator control cable from the accelerator control bracket.
6. Remove the accelerator control cable from the engine bracket.




7. Remove the accelerator control cable slug from the throttle pulley.




8. Remove the accelerator control cable bracket nuts.
9. Remove the accelerator control cable bracket with the cables attached, from the throttle body.
10. Position and secure the bracket and cables out of the way.




11. Disconnect the following electrical connectors:
- Throttle position (TP) sensor (1)
- Idle air control (IAC) valve (2)




12. Remove the throttle body studs.




13. Remove the throttle body.
14. Remove and discard the throttle body seal.

INSTALLATION PROCEDURE




1. Install a NEW throttle body seal and the throttle body.

NOTE: Refer to Fastener Notice.




2. Install the throttle body studs.

Tighten the studs to 9 N.m (80 lb in).




3. Connect the following electrical connectors:
- TP sensor (1)
- IAC valve (2)




4. Position the bracket and cables.
5. Install the accelerator control cable bracket with the cables attached, to the throttle body.
6. Install the accelerator control cable bracket nuts.

Tighten the nuts to 10 N.m (89 lb in).




7. Install the accelerator control cable slug to the throttle pulley.




8. Install the accelerator control cable to the engine bracket.
9. Install the accelerator control cable to the accelerator control bracket.




10. Install the cruise control cable to the engine bracket.
11. Install the cruise control cable to the throttle pulley.




12. Install the air cleaner outlet resonator stud.

Tighten the stud to 10 N.m (89 lb in).

13. Install the air cleaner outlet resonator.